How to increase your speed on a Gas Scooter (no hp parts)


Increase your speed!!! Without Buying HP Parts!!! Everybody: you must NOT keep your RPM’s high for a long period of time if you have done this modification. Once your motor reaches high RPM drop it down lower and then up again!This is very important!!! … Gas Scooters BladeZ Goped scooterx xtreme motor scooters mount

25 Responses to “How to increase your speed on a Gas Scooter (no hp parts)”

  1. crazytacostudios says:

    try looking on ebay or craigslist. if you cant find one there, you might just have to get creative

  2. 8tyman8 says:

    did the tire pop or did u break the rim

  3. TheDonOfChronic says:

    my gas scooter just broke today!
    anyone know where i can get a new one thats like my old one? or a replacement back wheel? ive looked everywhere
    cool video

  4. bmw97charlie says:

    ive done tht ut ppl around my area keep saying it too load i made a silencer but it dnt work at high revs help if any solutions and if u want to see my goped look at my videos

  5. mountmotor says:

    That’s fine. Still make a video. We can tell by the sound what might be the problem.

  6. crazytacostudios says:

    ok. now it wont start.

  7. mountmotor says:

    Sure.

  8. xma456 says:

    it’s probably the exhaust. Theres a little filter in all 2 stroke motors for the exhaust and when the filter gets all dirty with grim and oil then the motor will sound like its chocking when you rev it up. If i where you then id clean that out. And if that didn’t work then keep it on half choke so some of the exhaust doesn’t escape through the front because 2 strokes need to burn all of the fuel to keep going. Even some of the exhaust.

  9. crazytacostudios says:

    ok ill have it up soon

  10. crazytacostudios says:

    yah i can have it up in a day or 2

  11. mountmotor says:

    Is it possible for you to make a video of the scooter starting up…That will help a lot!

  12. crazytacostudios says:

    i checked. the carb is fine, and the filters ok to.

  13. mountmotor says:

    Check to see if there is anything obstructing the air filter or carb. If that is not the problem, let us know and we will help you further.

  14. crazytacostudios says:

    hey theres something wrong with my goped. its an old sport. when you start it, it will idle just fine. but when you give it gas, you can feel the strokes are more powerful, but it it stays at idle speed. and after you give it gas, it dies.

  15. westeh says:

    nitrose ? Don’t you mean Nitro?

  16. mountmotor says:

    This does not damage the engine. It just makes the engine make as much power as it was designed to do.

  17. xma456 says:

    Wouldn’t opening the throttle like that red line the motor?

  18. spunkflunk says:

    i just fill it up with nitrose lol

  19. pimpinpenz says:

    thats not good sounds like u have piston problem or u need a new carb

  20. NehpetsK57 says:

    I have a gas scooter and it does not reach its full speed, What is wrong?
    scooter is an XG-505 i replaced spark plugs and cleaned carburetor, also a blackish green fluid comes out of exhaust after I hit full throttle. Before it used to go about 25-28 now it goes 15-18. When I reach its full speed now (at 18) the engine kind of sputters and you can tell it can reach higher rpms

  21. HARJ1196 says:

    thanks bro
    apperictie datt

  22. mountmotor says:

    Maybe 2mph faster. You should feel a difference in acceleration. It is a quite faster.

  23. mountmotor says:

    We have a video online explaining how to do that.

  24. mend19348 says:

    how do i open the case covering all this

  25. mend19348 says:

    i have a 43Cc gas scooter if i do this to it how much fast do you think it will go

Leave a Reply